Saturday, November 23, 2019

The Keep - Rough Cuts

I decided to work on my Keep tonight. Of course, I will do floor plan maps, but tonight, I want to work on the model itself. I'm starting with the crenelation. You'll probably notice that this is bad form, I am making a model with no paper plans, then making a floor plan from an unscaled model. Hmmm... It could work.

To create the crenelations, I "measured" out the walls. I came up with 2 different numbers. 3 inches and 3 1/4 inches. Not bad considering the source of my Styrofoam was upcycled packing material. It wasn't going to be square no matter what I did.

I divided the wall section into five parts, a classic looking crenelation. 3 parts will be empty, 2 parts filled and then the 4 corners of unmeasured sizes. That works out to be about 9 1/16ths for the 3 inch sections and 10 1/16ths for the 3 1/4 walls. Small enough not to matter.

I put an x on the parts that would be cut away. One of the issues with this method is, I have no scale in mind. My brain defaults to 1 inch equals 6 feet, so a cut out of 10 1/16ths is going to be 3.75 feet. So this is 25 mm. This is pretty good, as most of my figures are 28mm. Oh... My brain is so broken.

Anyway, forget scale. I want this to look nice rather than be a particular size.
Although the Keep will not have a scale,
the cat is as close to 1:1 scale as it could get it.
Your cat may vary. 

Let's get cutting. I'm using scraper handled razor. I want to push down on the line. It turns out this cutter was bad for what I was doing and I switched it up with a boxing razor.

The straight down cut allows me to work in two angled cuts. Again, I am not working for a "scale", so I didn't measure how deep I went. I'm guessing that it's also about 3.75 feet in scale.

Let me give you two tips when cutting. First, unless you have a cutting table, work on a finished surface like a table. Wipe it down with a wet rag and do not it dry. The water will make the base of the Keep stick and all of the bits of Styrofoam will also stay in place.. This makes clean up easy. Dry, unfinished wood will also stick to Styrofoam, so that is an option, too.

These look like teeth. The blade is semi flexible, so I can force it into the soft Styrofoam, and end up with a straight cut and a flat surface on the bottom.

As you can see from the pictures, I have some basal wood pushed into the Styrofoam as a floor. I need to plan my details before the next step, which is going to force me to pick a scale. Judging by the size, this Keep will be nothing like a real world Keep. It is all out of proportion.

But I am happy with my results as of now. More tomorrow, I think.



2 comments:

  1. You are getting there! I'll send you a hot wire cutter before Christmas. Looks good so far. You can create blocks with a black ball point ink pen and draw it on the foam. Black because when if you decide to pain it the stone will look really good with a nice texture. Pain it black and then dry brush dark grey and then light grey. Good job.

    ReplyDelete
  2. Thanks! I am horribly out of practice.

    ReplyDelete